Chapter 22: Electrical: Firewall
Firewall: Cockpit Side Near Completion
I posted some of the initial layout of the firewall in the Ch 22 Electrical Planning page, and here I'm really looking back on what resulted as I'd reached completion of the Dynon and UL Power components in combination with establishing a firewall ground and odds and ends. You can see from the figure on the right that it got plenty busy in the end. It's interesting because there's fewer electrical components for backbone electrical, but this has shifted in these modern systems to more complicated sensing suites and associated control boxes, with many more small wire harnesses.
Red Box on right: UL Engine Control Unit. Black Box lower right: Dynon Engine Management System. Blue Bus Capacitor center. Master Solenoid above Capacitor. Fuse blocks on battery strap. Ground Block below Capacitor. 6 AWG going under armrest on left are routing to VP-X at Instrument Panel and Nose Gear Power. Small black boxes on left and right above spar = fuel level gage signal conditioning. Ammeter shunt above battery. Dual Fuel pumps and pre-filters below spar (not connected to blue hose from central sump yet).
Firewall: Engine Side Near Completion
I posted the prep work for this side with the SS sheet and fiberfrax in the Ch 22 Electrical Planning page, and here I'm posting a look at the engine side after the engine has been mounted to see a more populated back side. See captions below:
Top view between the cylinder cooling ducts and before installing the airbox/air filter for engine intake: - black Ignition coil blocks easily seen here - Big white bundle is UL engine control harness (pre-wired with engine) - Smaller white and colored wire bundles are instrumentation (CHT's, fuel flow's, oil and fuel pressures, oil temp) - Throttle push/pull shown with it's custom mount to clear the airbox (not shown) - braided steel fuel supply hose to right coming from fuel flow cube/fuel filter. - red cube seen bottom/center is for the fuel return to tanks